This is a pic of the board made this afternoon.
EDIT..... there is a mistake on the current diodes... do not make this board, or if you have already, then cut the tracks between the two anodes of the CT diodes and the two cathodes....duh! The anodes ned to be joined to each other and so do the cathodes.... but not the cathodes and anodes on the rectified side.
Here is pic of corrected part... the faulty one is at the end of post
...........oztules
and the pdf
80109A.pdf (43.32 kB - downloaded 670 times.)
BOM as it seems to be....will cross check when I get time.
"Comment","Pattern","Quantity","Components"
"","10PIN","1","A79"
"","SPADE","4","A51 A60 A61 A62"
"0r","AXIAL0.3","8","A1 A4 A13 A14 A17 A26 A34 A50"
"0r","AXIAL0.4","3","A27 A29 A52"
"0r","AXIAL0.5","1","A28"
"100r","AXIAL0.3","2","A77 A78"
"100uf 63v","RB.2/.4","1","A71"
"104","2PINCAP","3","A37 A75 A76"
"104","C1","2","A22 A23"
"104","C2","3","A10 A11 A12"
"104n","C1","1","A43"
"10k","AXIAL0.3","2","A38 A67"
"10k","AXIAL0.4","2","A6 A40"
"10k","POT","1","A47"
"10uf","C2","2","A5 A8"
"10uf","C2S","4","A18 A19 A20 A21"
"120r","AXIAL1.1","1","A7"
"13v","DIODE0.4","1","A39"
"1k","AXIAL0.3","2","A33 A63"
"1k","C2","1","A74"
"1n","C2","1","A73"
"1n4007","DIODE2","1","A59"
"2110","DIP14","2","A2 A3"
"22pf","C1","2","A30 A31"
"2k","POT","1","A46"
"2uf","11PINCAP","2","A9 A69"
"4007","DIODE2","7","A53 A54 A55 A56 A57 A58 A64"
"4u7","C2","3","A15 A41 A42"
"4u7","C2S","2","A68 A70"
"50k","AXIAL0.3","4","A48 A49 A65 A66"
"5v6","D3","1","A16"
"8010","801032","1","A72"
"fr107","D3","1","A80"
"fr107","D3","1","A25"
"led","LED","1","A32"
"tip35c","TO220V","2","A35 A36"
"xtal","RAD0.2","1","A24"
Yes it is messed up from how the pro's do it, but I never have used this before, so don't get too carried away with filling out the form for each component.
Here is the faulty part.... needs to separate the cathodes from the anodes... they are short circuit on the board..... makes the current signal pointless really....