Hi.
When the batteries are less that half charged and try to start a 2000W motor, the voltage drips and the PJ goes into fault mode, beeping continuously and ceasing to output voltage. This is quite limiting for me as the PJ is installed in a weekend house and I have a few things that should run controlled via timer. Sometimes I arrive to fully charged batteries, beeping PJ and all systems down...
Long story short, is there any (easy) way of setting the PJ into auto fault clearing mode?
I was thinking of replacing the ON/OFF switch by a relay that would switch OFF after the fault, wait for a couple of hours to let the batteries charge on the sun and then switch on. But I cannot see any obvious place where I could get the fault signal from (maybe the only place is the beeping thing?)
Another, less elegant solution, could be to just control the relay so it'd switch on and off once or twice a day?
Any ideas welcome!
Cheers,
Rob