New here so I am not sure if I have put this in the right place. I have built dual rotor alts before but not something thats engine driven and am looking for some direction as to the winding's.
This engine was hooked up to a 1200 watt alt 120volts ac 10 amp, I have removed the alt as you can see, then measured for the room to mount a flywheel, I have room for a 8 to 8.5 inch disk, I am thinking half inch thick. I would like to just use a single rotor, I dont want a lot of weight hanging of the end of this shaft.
So lets say a single 8 inch disk, 1 inch round neo mags, 1/4 inch thick (maybe 3/8th), a 12 mag 9 coil arraingment. target RPM's 1800- 2000...DC amps out for a 12 volt system around 20 to 30 amps . for a hard number lets say 25 amps.
thought's any and all please..Gauge, winding turn's, delta, star?