Lot of these at my place....So why not?
Cut in half and top ends welded together,
Not too difficult with the nozzle of a Mini-Glue
gun ....Hi-Temp model ....no low temp cause
it doesn't get hot enough, soldering pencil gets
too hot unless you have a temp control, or plugging
in on and off continuously . Pain....
Easier using a Hi-Temp gun .....slower but gives best
results IMO.
So here they are the first of perhaps 2 or 3 stage .....
depending on the wind and the amount of torque needed
to overcome the cogging of my little stepper motors.
Would like it to be large enough to charge 6 volt NiCads 1.3
Amp/hr.
I'll put a second stage at 90 degrees to this one or a 3 stage at 120
degrees to each other .
Not a very clue view but I hope you get the idea.
BTW there will be a future view of it here when I get it spinning.
Here is where I view as I watch from the front room window at
My projects .
Thanks for watching !
Norm.