everyday I work on the cell holder for cordless drills ....cold weather has been slowing me down
not to mention the endless modifications.....I've finally settled on a good model that I'm going to stick with.
I've decided to not use the tubes for others use .....looks too bulky and clumsy ......I've made a container
that holds 6 batteries 2 cells stacked endwise in each and although the batteries can be removed and
replaced ....later on they will remain in the container unless some of the cells happen to go south the user
of these will have 3 or 4 containers that can be kept charged and ready to go .
The end plates have two wooden dowels that run from one end to the other as shown.
one end plate has contact points and the other end has springs.
Right now I'm working on the top where the base of the drill is slid on and plugged in
Once I go into production on this type I'll use a router to make the channel that the drill slides into .
Here are some pictures of what I have so far ....crude but not pretty.
Hope you like 'em .
Norm.