Thank you very much.
Yes both boards done, here's the Power Board.......
Putting it all together now.... for the BigOzInverter, then we will see....... gulp!.
I do not like spade connectors on the control board at 10mm/2, but another insulated box with the CT sense coil and two bolt and eye connections seems a bit OTT. So thinking about the secondary output cabling if I can feed back to the control card at my EMC Filter assembly unit, where the two Secondary cable would have its first connections, ? I would use 10mm/2 cable. Could put sense coil on the secondary before the EMC filter.
The control board is just single sided with a few top jumpers. Those SMD connections need a steady iron, by the 3rd chip/ card I had it sorted.
Just got a batch of 30off 8010's with the HT1536.