I am not an electronic wizz kid like most of you guys, so here goes.
As I put together and layout this New Power Board that will be driven by the New OzControl Board with that new 8010 chip, I have slight issues and questions about particular components I have found on the Old 8kW -15kW PJ Board.
Number 1................
Firstly The Fet gates resistors will be 20k 0.6w metal film and 5r6, with a signal diode 4148, (anode towards gate) in parallel with the 5r6.
As I move things about to get those extra 48 holes, signal diodes, in the New board, I am also going to replace the old PJ 2W metal film 47r resistor, 4 per board, with a 2W 5r6, this just feeds to that 100n disc capacitor and not a gate. OKAY?
I presume that a parallel signal diode will not be required on this particular 2Wresistor.?