Author Topic: F'ing an E core  (Read 2221 times)

0 Members and 1 Guest are viewing this topic.

Offline frackers

  • Full Member
  • ***
  • Posts: 239
  • Karma: +9/-0
  • If it moves - computerise it!
F'ing an E core
« on: August 23, 2016, 07:15:10 am »
Gggrrrrrr

Just got a nice new 65mm E core arrived today and within 10 minutes I'd made half of it into an F core. Primary wire is just a fraction too thick ;(

Do they superglue OK?

I've a 70mm one on its way just in case - the extra 2mm each side should give me the space I need.


Robin Down Under (or are you Up Over!)

Offline oztules

  • Forum Advisors
  • Hero Member
  • ****
  • Posts: 1177
  • Karma: +105/-8
  • Village idiot
Re: F'ing an E core
« Reply #1 on: August 23, 2016, 03:05:53 pm »
superglue will do fine.


.............oztules
Flinders Island...... Australia

Offline frackers

  • Full Member
  • ***
  • Posts: 239
  • Karma: +9/-0
  • If it moves - computerise it!
Re: F'ing an E core
« Reply #2 on: August 28, 2016, 05:49:09 am »
All glued up OK and nice and quiet (compared to the hacked up multiple 'C' core setup I tried.

Idle current is 1.6A which is a little higher than I'd hoped but now I have the steel frame made up I can get everything together into a box with fans & monitor electronics.
Robin Down Under (or are you Up Over!)

Offline oztules

  • Forum Advisors
  • Hero Member
  • ****
  • Posts: 1177
  • Karma: +105/-8
  • Village idiot
Re: F'ing an E core
« Reply #3 on: August 28, 2016, 03:57:30 pm »
It is a little high, but with a home formed transformer, to be expected, as I assume the insulation between foils is not perfect now.
Perhaps when the bigger ferrite comes, wind it as well and series it, and that may pull it down some more.

Don't forget the pics as we go... for you for posterity, and for me coz I'm a sticky beak ::)

...........oztules
Flinders Island...... Australia